|
| | | Forum Newbie
Group: Forum Members
Last Login: 1/28/2008 11:33:41 PM
Posts: 6, Visits: 15 |
| My Brute Force will not start when the motor is cold, if you are able by chance to get it started you have to hold the gas on by hand
to keep it running, the choke in on position will make it crap out.
Once it's warm it run and starts fine, anybody had this issue?
|
| |
| | | Forum Newbie
Group: Forum Members
Last Login: 11/15/2007 7:29:02 AM
Posts: 2, Visits: 5 |
|
i have the same 4wheeler doing the same thing. i haven't been able to fix it yet. starting fluid doesn't even help start it. |
| |
| | | Forum Newbie
Group: Forum Members
Last Login: 11/15/2007 7:29:02 AM
Posts: 2, Visits: 5 |
| | adjusted your valves. .005'' on the intake and .008 on exhaust. mine starts and runs like a new one know. |
| |
| | | Forum Newbie
Group: Forum Members
Last Login: 1/28/2008 11:33:41 PM
Posts: 6, Visits: 15 |
| Where did you get those setting from?
The book calls for 0.20 - 0.25 on the exhaust & 0.10 - 0.15 inlet
cold settings.
Mine are within the factory range settings.
Where were your settings, before you did your adjustments?
And was that cold are hot settings? ( before and after adjustments ) |
| |
| | | Forum Newbie
Group: Forum Members
Last Login: 1/28/2008 11:33:41 PM
Posts: 6, Visits: 15 |
| It was the valves needing adjustment, and the choke was hanging up a little bit, 0.11 on intake & 0.22 on the exaust and starts & runs fine. ;
|
| |
|
|